[Gmsh] Extrusion and Rotation
David.Colignon at ulg.ac.be
Wed Jun 2 08:20:49 CEST 2010
I am not sure that it is what you want, but there is a problem with the x and z components of the translation, and here
is a working version of your .geo file.
There also was an inversion between the inner and the outer circle.
David Colignon, Ph.D.
Collaborateur Logistique du F.R.S.-FNRS
CÉCI - Consortium des Équipements de Calcul Intensif
ACE - Applied & Computational Electromagnetics
Université de Liège
4000 Liège - BELGIQUE
Tél: +32 (0)4 366 37 32
Fax: +32 (0)4 366 29 10
On 01/06/10 18:17, Gabriel Beu Nogueira de Macedo wrote:
> Hi all,
> I got a problem when I tried to make a coil using extrusion and rotation
> of a axisymmetric 2D drawing. In this situation, the coil increases in
> each cycle. But the new top surface (that is created right) doesn't
> match with the rotated curves. I hope someone can help me.
> * The .geo file is attached
> ** The y-axis view is the best to see what happened.
> Gabriel Macedo.
> gmsh mailing list
> gmsh at geuz.org
-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
More information about the gmsh