[Gmsh] Controlling curvature factor with Mesh.CharacteristicLengthFromCurvature

[Neilen Marais]

Christophe,

On Fri, 14 Nov 2008 19:24:18 +0100, Christophe Geuzaine wrote:

> Neilen Marais wrote:

> Try changing Mesh.MinimumCirclePoints

Thanks for the info. This does indeed control the curvature meshing, but 
at the smallest value it is still much finer that I need. Setting 
MinimumCirclePoints to fractional values less than 1 seems to disable the 
curvature meshing. With 

Mesh.MinimumCirclePoints = 1;

about 24 edges per 90 degrees of a circle is generated, whereas I'd like 
to be able to adjust it from say 5 edges per 90 degrees or so. Can this 
be done?


>> I was using gmsh 2.2.0 but just tried 2.2.5 (with tetgen) with the same
>> result. I notice 2.2.5 doesn't have a "ligting" tab under options any
>> more, is there any other way to enable/disable mesh lighting?
> 
> -> in the Color tab

Thanks! I think this is better than the old UI, I just didn't find it the 
first time I looked :)

Regards
Neilen